How To Remove A Bathroom Sink Cabinet Floor Tiles

How to Remove a Bathroom Sink Cabinet Floor Tiles

Bathroom sink cabinet floor tiles can become damaged, outdated, or simply in need of a refresh. Replacing them can give your bathroom a whole new look. While it may seem like a daunting task, removing bathroom sink cabinet floor tiles is a project that can be completed by most do-it-yourselfers with the right tools and a little bit of elbow grease.

Gather Your Tools and Supplies

Before you begin, gather all of the tools and supplies you will need. This includes:

Safety glasses
Work gloves
Pry bar
Hammer
Chisel
Putty knife
Bucket
Grout saw
New floor tiles
Thin-set mortar
Grout

Prepare the Area

Once you have your tools and supplies, you need to prepare the area. This means removing any items from the bathroom cabinet and sink. You should also turn off the water supply to the sink and disconnect the drain.

Remove the Old Tiles

Now it's time to remove the old tiles. Start by using a grout saw to cut around the perimeter of the tiles. This will help to loosen them. Once the grout is cut, use a pry bar to carefully pry up the tiles. Be careful not to damage the subfloor underneath.

Clean the Subfloor

Once the old tiles are removed, you need to clean the subfloor. This will help to ensure that the new tiles adhere properly. Use a putty knife to scrape away any remaining grout or adhesive. Then, sweep and vacuum the subfloor to remove any debris.

Install the New Tiles

Now you're ready to install the new tiles. Start by applying a thin layer of thin-set mortar to the subfloor. Use a trowel to spread the mortar evenly. Then, carefully place the new tiles into the mortar. Use a rubber mallet to tap the tiles into place. Make sure that the tiles are level and properly spaced.

Grout the Tiles

Once the tiles are installed, you need to grout them. This will help to fill in the gaps between the tiles and create a watertight seal. To grout the tiles, simply mix the grout according to the manufacturer's instructions. Then, apply the grout to the tiles using a grout float. Work the grout into all of the gaps between the tiles. Allow the grout to dry completely before using the sink.