How To Make A Template Install Cabinet Pulls

How to Template Install Cabinet Pulls

Installing cabinet pulls is a relatively simple task that can be completed with basic tools. However, using a template to ensure that the pulls are installed evenly and accurately can make the process much easier.

To make a template, you will need:

A piece of cardboard or thin plywood
A measuring tape
A pencil
A drill
Screws

Instructions:

Measure the distance between the centers of the holes on the cabinet pull.
Transfer this measurement to the cardboard or plywood and draw a line.
Measure the distance from the top of the cabinet pull to the center of the hole.
Transfer this measurement to the cardboard or plywood and draw a line perpendicular to the first line.
Drill a hole at the intersection of the two lines.
Place the template over the cabinet door or drawer and align the hole with the desired location for the cabinet pull.
Drill pilot holes through the template.
Remove the template and insert the screws through the pilot holes.
Tighten the screws until the cabinet pull is secure.

Here are some additional tips for installing cabinet pulls:

Use a level to ensure that the cabinet pulls are installed straight.
If you are installing pulls on multiple cabinets or drawers, make sure to use the same template for each one to ensure that they are all installed evenly.
If you are not sure how to install cabinet pulls, consult with a professional.

By following these steps, you can easily install cabinet pulls using a template. This will help to ensure that the pulls are installed evenly and accurately, and will give your cabinets a professional-looking finish.